Chapter 17 User/Group
NXC Series User’s Guide
204
User idle
timeout
This is applicable for access users.
This field is effective when Enable user idle detection is checked. Type the number of
minutes each access user can be logged in and idle before the NXC automatically logs
out the access user.
User Logon Settings
Limit the
number of
simultaneous
logons for
administration
account
Select this check box if you want to set a limit on the number of simultaneous logins by
admin users. If you do not select this, admin users can login as many times as they
want at the same time using the same or different IP addresses.
Maximum
number per
administration
account
This field is effective when Limit ... for administration account is checked. Type the
maximum number of simultaneous logins by each admin user.
Limit the
number of
simultaneous
logons for
access account
Select this check box if you want to set a limit on the number of simultaneous logins by
non-admin users. If you do not select this, access users can login as many times as
they want as long as they use different IP addresses.
Maximum
number per
access account
This field is effective when Limit ... for access account is checked. Type the
maximum number of simultaneous logins by each access user.
User Lockout
Settings
Enable logon
retry limit
Select this check box to set a limit on the number of times each user can login
unsuccessfully (for example, wrong password) before the IP address is locked out for a
specified amount of time.
Maximum retry
count
This field is effective when Enable logon retry limit is checked. Type the maximum
number of times each user can login unsuccessfully before the IP address is locked out
for the specified lockout period. The number must be between 1 and 99.
Lockout period This field is effective when Enable logon retry limit is checked. Type the number of
minutes the user must wait to try to login again, if logon retry limit is enabled and the
maximum retry count is reached. This number must be between 1 and 65,535 (about
45.5 days).
Dynamic Guest
Settings
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove
it before doing so. Removing a group does not remove the user accounts in the group.
Object Reference Select an entry and click Object Reference to open a screen that shows which settings
use the entry.
# This field is a sequential value, and it is not associated with a specific user group.
Group Name This field displays the name of each dynamic guest group.
Description This field displays the description for each dynamic guest group.
Account Deleted
After Expiration
Select this check box to remove the dynamic guest accounts from the Monitor >
System Status > Dynamic Guest screen when they expire.
Dynamic Guest
Note
Enter the notes (such as the SSID and security key the dynamic guests can use to
access the network services) you wan to display in the paper along with the account
information you print out for dynamic guest users. You can enter up to 1024 ASCII
characters.
Table 101 Configuration > Object > User/Group > Setting (continued)
LABEL DESCRIPTION
To Next Page
Loading...
