Chapter 29 Log and Report
NXC Series User’s Guide
336
Figure 200 Configuration > Log & Report > Log Settings > Edit (USB Storage)
The following table describes the labels in this screen.
Table 175 Configuration > Log & Report > Log Settings > Edit (USB Storage)
LABEL DESCRIPTION
Duplicate logs to
USB storage (if
ready)
Select this to have the NXC save a copy of its system logs to a connected USB storage
device. Use the Active Log section to specify what kinds of messages to include.
Active Log
Selection Use the Selection drop-down list to change the log settings for all of the log categories.
disable all logs (red X) - do not send the remote server logs for any log category.
enable normal logs (green check mark) - send the remote server log messages and
alerts for all log categories.
enable normal logs and debug logs (yellow check mark) - send the remote server log
messages, alerts, and debugging information for all log categories.
# This field is a sequential value, and it is not associated with a specific entry.
Log Category This field displays each category of messages. The Default category includes debugging
messages generated by open source software.
To Next Page
Loading...
