Appendix A Log Descriptions
NXC Series User’s Guide
410
AP Receiving Complete ZySH
Configuration from WLAN
Controller.
WTP receiving total configuration from WLAN Controller during
CAPWAP protocol handshaking. (Configuration Change State)
AP Receiving Updating ZySH
Configuration from WLAN
Controller.
WTP receiving total configuration from WLAN Controller When
AC changed configuration. (RUN State)
STA List Full. STA List of AP [%s]
is Full
Number of stations connecting to the specified AP has reached
its upper limit.
1st %s: WTP's description.
DNS Query result is NULL.
A DNS query failed.
Table 214 AP Load Balancing Logs
LOG MESSAGE DESCRIPTION
kick station
%02x:%02x:%02x:%02x:%0
2x:%02x
Indicates that the specified station was removed from an AP’s wireless
network because the AP became overloaded.
Table 215 Rogue AP Logs
LOG MESSAGE DESCRIPTION
rogue ap detection is
enabled.
Indicates that rogue AP detection is enabled.
Table 216 Wireless Frame Capture Logs
LOG MESSAGE DESCRIPTION
Capture done!
check_size:%d,
max_file_size:%d\n
This message displays check_size %d and max_file_size %d when the wireless
frame capture has been completed.
1st %d: total files size of directory.
2nd %d: max files size.
Can not initial
monitor mode signal
handler.\n
While an AP is in Monitor mode, the handler functions as a daemon; if it fails to
initialize the handler, then this message is returned.
Table 217 DCS Logs
LOG MESSAGE DESCRIPTION
dcs init failed!\n
Indicates that the NXC failed to initialize the dcs daemon.
init zylog fail\n
Indicates that the NXC failed to initialize zylog.
Table 213 CAPWAP Client Logs
LOG MESSAGE DESCRIPTION
To Next Page
Loading...
