Chapter 7 Wireless
NXC Series User’s Guide
97
Each field is described in the following table.
Table 49 Configuration > Wireless > AP Management > Edit AP List
LABEL DESCRIPTION
Create new Object Use this menu to create a new Radio Profile, MON Profile or ZyMesh Profile object
to associate with this AP.
MAC This displays the MAC address of the selected AP.
Model This field displays the AP’s hardware model information. It displays N/A (not
applicable) only when the AP disconnects from the NXC and the information is
unavailable as a result.
Description Enter a description for this AP. You can use up to 31 characters, spaces and underscores
allowed.
The system automatically generates a default name in the format of AP-xxxxxxxxxxxx
(where xxxxxxxxxxxx is the AP’s MAC address).
Group Setting Select an AP group to which you want this AP to belong.
Radio 1/2 Setting
Override Group
Radio Setting
Select this option to overwrite the AP radio settings with the settings you configure
here.
OP Mode Select the operating mode for radio 1 or radio 2.
AP Mode means the AP can receive connections from wireless clients and pass their
data traffic through to the NXC to be managed (or subsequently passed on to an
upstream gateway for managing).
MON Mode means the AP monitors the broadcast area for other APs, then passes their
information on to the NXC where it can be determined if those APs are friendly or
rogue. If an AP is set to this mode it cannot receive connections from wireless clients.
Root AP means the radio acts as an AP and also supports the wireless connections with
other APs (in repeater mode) to form a ZyMesh/WDS to extend its wireless network.
Repeater AP means the radio can establish a wireless connection with other APs (in
either root AP or repeater mode).
Note: To prevent bidge loops, do NOT set both radios on a managed AP to Repeater AP
mode.
Note: The root AP and repeater AP(s) in a ZyMesh must use the same country code and
AP radio profile settings in order to communicate with each other.
Note: Ensure you restart the managed AP after you change its operating mode.
Radio 1/2 AP Profile Select an AP profile from the list. If no profile exists, you can create a new one through
the Create new Object menu.
Radio 1/2 Profile Select a monitor profile from the list. If no profile exists, you can create a new one
through the Create new Object menu.
Radio 1/2 ZyMesh
Profile
This field is available only when the radio is in Root AP or Repeater AP mode.
Select the ZyMesh profile the radio uses to connect to a root AP or repeater.
Override Group
Output Power
Setting
Select this option to overwrite the AP output power setting with the setting you
configure here.
Output Power Set the output power of the AP.
Override Group
SSID Setting
Select this option to overwrite the AP SSID profile setting with the setting you configure
here.
This section allows you to associate an SSID profile with the radio.
To Next Page
Loading...
