ZyXEL Communications P-660HW-T V2 - VERSION 3.40 User Manual

P-660HW-T v2 User’s Guide
Chapter 2 Introducing the Web Configurator 43
Figure 6 Select a Mode
Note: The management session automatically times out when the time period set in
the Administrator Inactivity Timer field expires (default five minutes). Simply
log back into the ZyXEL Device if this happens to you.
2.3 Resetting the ZyXEL Device
If you forget your password or cannot access the web configurator, you will need to use the
RESET button at the back of the ZyXEL Device to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously and the password
will be reset to “1234”.
2.3.1 Using the Reset Button
1 Make sure the POWER LED is on (not blinking).
2 Press the RESET button for ten seconds or until the POWER LED begins to blink and
then release it. When the POWER LED begins to blink, the defaults have been restored
and the ZyXEL Device restarts.
2.4 Navigating the Web Configurator
2.4.1 Navigation Panel
After you enter the admin password, use the sub-menus on the navigation panel to configure
ZyXEL Device features. The following table describes the sub-menus.

ZyXEL Communications P-660HW-T V2 - VERSION 3.40 Specifications

General

Brand	ZyXEL Communications
Model	P-660HW-T V2 - VERSION 3.40
Category	Gateway
Language	English