PMG5318-B20B User’s Guide
100
CHAPTER 20
Voice
20.1 SIP Global Parameters
The GPON Device uses a SIP (Session Initiation Protocol) account for VoIP (Voice over Internet
Protocol) calls. Click Voice > SIP Basic Setting to open the Global Parameters screen.
Figure 81 SIP Global Parameters
20.2 SIP Service Provider
Click Voice > SIP Basic Setting > Service Provider to open the following screen. Use this
screen to configure each SIP account’s basic settings. Your VoIP service provider (the company that
lets you make phone calls over the Internet) should provide this.
Table 73 SIP Global Parameters
LABEL DESCRIPTION
Bound Interface
Name
Select a specific WAN interface to use for SIP traffic or select Any_WAN to let the
GPON Device use any of its WAN interfaces for SIP traffic.
IP Address Family Select the network protocol to use for SIP traffic. The GPON Device supports IPv4 at
the time of writing.
Apply Click this to save your changes and to apply them to the GPON Device.
To Next Page
Loading...
