ZyXEL Communications PMG5318-B20B - WAN Service Configuration

Chapter 4 WAN
PMG5318-B20B User’s Guide
23
4.2.1 WAN Service Configuration
Click the Edit or Add button in the WAN Service screen to configure a WAN connection.
4.2.1.1 WAN Service Interface Configuration
This screen displays when you add a new WAN connection.
Table 11 WAN Service
LABEL DESCRIPTION
Interface This shows the name of the interface used by this connection.
veip0 stands for a virtual Ethernet card and is the foundation for veip0/* which are virtual
WAN interfaces of the physical GPON line. The ppp0.* indicates a PPP connection.
The number after the dot (.) represents the VLAN ID number assigned to traffic sent through
this connection. The number after the underscore (_) represents the index number of
connections through the same interface.
(null) means the entry is not valid.
Description This is the service name of this connection.
Type This shows the method of encapsulation used by this connection (IP over Ethernet, PPP over
Ethernet, or bridging).
Vlan8021p This indicates the IEEE 802.1P priority level assigned to traffic sent through this connection.
This displays N/A when there is no priority level assigned.
VlanMuxId This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
VlanTpid This field displays the VLAN Tag Protocol Identifier (TPID), a four-digit hexadecimal number
from 0000 to FFFF that the OLT adds to the matched packets.
Igmp Proxy This shows whether IGMP (Internet Group Multicast Protocol) proxy is activated or not for this
connection. IGMP is not available when the connection uses the bridging service.
Igmp Source This shows whether IGMP source is activated or not for this connection.
NAT This shows whether NAT is activated or not for this interface. NAT is not available when the
connection uses the bridging service.
IPv6 This shows whether IPv6 is activated or not for this connection. IPv6 is not available when the
connection uses the bridging service.
Mld Proxy This shows whether Multicast Listener Discovery (MLD) proxy is activated or not for this
connection. MLD is not available when the connection uses the bridging service.
Mld Source This shows whether MLD source is activated or not for this connection.
Remove Select an interface and click the Remove button to delete it. You cannot remove a layer-2
interface when a WAN service is associated with it.
Edit Click the Edit button to configure the WAN connection.
Click the Remove icon to delete the WAN connection.
Add Click Add to create a new connection.