ZyXEL Communications PMG5318-B20B - LAN Statistics

Chapter 3 Device Info
PMG5318-B20B User’s Guide
16
Figure 7 WAN Info
3.3 LAN Statistics
Click Device Info > Statistics > LAN to open this screen of traffic statistics counters for the
GPON Device’s wired and wireless LAN interfaces. Use the button to clear the counters.
Table 3 WAN Info
LABEL DESCRIPTION
Interface This shows the name of the WAN interface. veip0 stands for a virtual Ethernet card and is
the foundation for veip0/* which are virtual WAN interfaces of the physical GPON line. The
ppp0.* indicates a PPP connection.
The number after the dot (.) represents the VLAN ID number assigned to traffic sent
through this connection. The number after the underscore (_) represents the index number
of connections through the same interface.
(null) means the entry is not valid.
Description This is the service name of this connection.
Type This shows the method of encapsulation used by this connection (IP over Ethernet, PPP over
Ethernet, or bridging).
VlanMuxID This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
IPv6 This displays whether or not IPv6 is enabled on the interface.
Igmp Pxy This shows whether IGMP (Internet Group Multicast Protocol) proxy is activated or not for
this connection. IGMP is not available when the connection uses the bridging service.
Igmp Src Enbl This shows whether IGMP source enable is activated or not for this connection. IGMP source
enable has the GPON Device add routing table entries based on the IGMP traffic.
MLD Pxy This shows whether Multicast Listener Discovery (MLD) proxy is activated or not for this
connection. MLD is not available when the connection uses the bridging service.
MLD Src Enbl This shows whether MLD source enable is activated or not for this connection. MLD source
enable has the GPON Device add routing table entries based on the MLD traffic.
NAT This shows whether NAT is activated or not for this interface. NAT is not available when the
connection uses the bridging service.
Firewall This shows whether the firewall is activated or not for this interface.
Status This displays the connection state or Unconfigured if the interface has not yet been
configured.
IPv4 Address This displays the interface’s current IPv4 address if it has one.
IPv6 Address This displays the interface’s current IPv6 address if it has one.