Chapter 3 Device Info
PMG5318-B20B User’s Guide
19
Figure 10 Route Info
3.6 ARP Info
Click Device Info > ARP to display the GPON Device’s IPv4 Address Resolution Protocol and IPv6
neighbor tables. This screen lists the IP addresses the GPON Device has mapped to MAC addresses.
Figure 11 ARP Info
Table 6 Route Info
LABEL DESCRIPTION
Destination This displays the IP address to which this entry applies.
Gateway This displays the gateway the GPON Device uses to send traffic to the entry’s destination
address.
Subnet Mask This displays the subnet mask of the destination net.
Flag This displays whether the route is up (U), the GPON Device drops packets for this
destination (!), the route uses a gateway (G), the target is in the neighbor cache (C), the
target is a host (H), reinstate route for dynamic routing (R), the route was dynamically
installed by redirect (D), or modified from redirect (M).
Metric The metric represents the “cost” of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly-connected networks.
Service The name of a specific service to which the route applies if one is specified.
Interface The interface through which this route sends traffic.
Table 7 ARP Info
LABEL DESCRIPTION
IP address The learned IP address of a device connected to one of the system’s ports.
Flags Static - static entry, Dynamic - dynamic entry that is not yet complete, Complete -
dynamic entry that is complete.
HW Address The MAC address of the device with the listed IP address.
Device The interface through which the GPON Device sends traffic to the device listed in the entry.
To Next Page
Loading...
