Chapter 4 WAN
PMG5318-B20B User’s Guide
34
4.2.1.7 Configuration Summary
This read-only screen lets you review a summary of the WAN connection settings before you apply
them.
Figure 23 WAN Service: Configuration Summary
Primary DNS
server
Enter the first DNS server address assigned by the ISP.
Secondary DNS
server
Enter the second DNS server address assigned by the ISP.
Obtain IPv6 DNS
info from a WAN
interface
Select this to have the GPON Device get the IPv6 DNS server addresses from the ISP
automatically.
WAN Interface
selected
Select a WAN interface through which you want to obtain the IPv6 DNS related
information.
Use the following
Static IPv6 DNS
address
Select this to have the GPON Device use the IPv6 DNS server addresses you configure
manually.
Primary IPv6
DNS server
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary IPv6
DNS server
Enter the second IPv6 DNS server address assigned by the ISP.
Back Click this button to return to the previous screen.
Next Click this button to continue.
Table 18 WAN Service: DNS Server: PPPoE or IPoE (continued)
LABEL DESCRIPTION
Table 19 WAN Service: Configuration Summary
LABEL DESCRIPTION
Connection Type This is the encapsulation method used by this connection.
NAT This shows whether NAT is active or not for this connection.
Full Cone NAT This shows whether full cone NAT is active or not for this connection.
Firewall This shows whether the firewall is active or not for this connection.
IGMP Multicast
Proxy
This shows whether IGMP proxy is activated or not for this connection. IGMP is
not available when the connection uses the bridging service.
To Next Page
Loading...
