Chapter 7 Security
PMG5318-B20B User’s Guide
52
7.3 MAC Filtering Setup
Click Advanced Setup > Security > MAC Filtering to display the following screen. This screen
displays a list of the configured MAC address filtering rules.
MAC Filtering
Table 33 MAC Filtering
LABEL DESCRIPTION
MAC Filtering Policy
For Each Interface
Interface This displays the interface to which this rule is applied.
Policy This displays the MAC filtering policy for each WAN interface in bridge mode on the
GPON Device. By default, the GPON Device allows all frames to pass through the bridge
connection.
Change Select the check box next to the interface for which you want to change the MAC
filtering policy.
Change Policy Select the Change check box and click Change Policy to have the GPON Device
change to block or allow all frames on this interface.
Interface This displays the WAN interface(s) to which this rule is applied.
Protocol This displays the IP protocol (PPPoE, IPv4, IPv6, AppleTalk, IPX, NETBEUI or
IGMP) to which this rule applies.
Destination MAC This displays the destination MAC address to which this rule applies.
Source MAC This displays the source MAC address to which this rule applies.
Frame Direction This indicates the traffic direction in which the filtering occurs (LAN <=> WAN, LAN
=> WAN, WAN => LAN).
Remove Select the rule(s) you want to delete in the Remove column and then click the Remove
button.
Add Click Add to create a new rule.
Remove Click Remove to delete the selected rule(s).
To Next Page
Loading...
