Chapter 4 WAN
PMG5318-B20B User’s Guide
22
Figure 14 GPON Interface Configuration
4.2 WAN Service
Use this screen to change your GPON Device’s WAN settings. Click Advanced Setup > WAN
Service. The summary table shows you the configured WAN services (connections) on the GPON
Device.
To use NAT, firewall or IGMP proxy in the GPON Device, you need to configure a WAN connection
with PPPoE or IPoE.
Note: When a layer-2 interface is in VLAN MUX Mode, you can configure up to five WAN
services on the GPON Device.
Figure 15 WAN Service
Table 10 GPON Interface Configuration
LABEL DESCRIPTION
Select a GPON port Select a GPON port. veip0 stands for a virtual Ethernet card and is the foundation for
veip0/* which are virtual WAN interfaces of the physical GPON line.
Back Click this button to return to the previous screen without saving any changes.
Apply/Save Click this button to save your changes and go back to the previous screen.
To Next Page
Loading...
