Chapter 1 Introduction
PMG5318-B20B User’s Guide
11
1.5 Reset Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to the default.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for more than 5
seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins
to blink, the defaults have been restored and the device restarts.
1.6 WLAN Button
Press the WLAN button on the back of the device for more than 1 second to enable or disable the
wireless LAN.
1.7 WPS Button
Use the WPS button on the back of the device to activate WPS in order to quickly set up a wireless
network with strong security.
1 Make sure the POWER LED is on (not blinking).
2 Press the WPS button for more than 1 second to activate WPS.
3 Press the WPS button on a compatible device within 2 minutes of pressing the button on the GPON
Device. The WLAN LED should flash in orange while the GPON Device sets up a WPS connection
with the other wireless device.
4 Once the connection is successfully made, the WLAN LED shines green.
Wi-Fi
2.4G
Green On The wireless network is activated.
Blinking The GPON Device is communicating with other wireless clients.
Off The wireless network is not activated.
Orange Blinking The GPON Device is setting up a WPS connection.
Table 1 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
