Chapter 9 Routing
PMG5318-B20B User’s Guide
60
9.3.1 Add Policy Routing
Click Add in the Policy Routing screen to open the following screen. Use this screen to configure
the required information for a policy route.
Figure 46 Policy Routing: Add
9.4 RIP
Click Advanced Setup > Routing > RIP to open the RIP screen. Use this screen to configure RIP
settings. Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange
routing information with other routers.
Table 42 Policy Routing: Add
LABEL DESCRIPTION
Policy Name Enter a descriptive name of printable English keyboard characters, not including spaces.
Physical LAN Port Select the source LAN Ethernet port number.
Source IP Enter the source IP address.
Use Interface Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Default Gateway
IP
Enter the default gateway IP address the route uses.
Apply/Save Click this button to save your changes.
To Next Page
Loading...
