2gig Technologies EDGE - Arming in Away Mode and Notes

2GIG EDGE Smart Home Manual
22
Screensaver: My Photos
1. On the Screensaver option, tap >.
2. To display your own photos, follow
instructions outlined for the Main Panel.
Once congured, the Remote Keypad will
display photos loaded on the Main Panel.
NOTE: The USB ash drive must be formated FAT/
FAT32.
Screen Saver - Replace Photos
Changing Screensaver Settings
Select from the following settings to adjust how your Screen Saver Photos are displayed:
1. Photo Duration – Select how long each photo will display before transitioning to the next photo (Options 30
seconds, 1, 2, or 5 minutes).
2. Transition Effect – (Options: None, Fade, Push, and Wipe).
3. Transition Duration – Number of seconds to transition between photos. (Options: 2, 3, or 5 seconds).
4. Display Sequence – Order in which the photos are displayed. (Options: By Photo Name, Shufe (Random).
5. Full Landscape Mode – Tap to Enable or Disable.
Clean Screen
To clean the screen without affecting on-screen functions, press START for 30 seconds available for cleaning.
Wipe the touchscreen with a soft, dry, microber cloth that is specially designed for cleaning sensitive surfaces.
WARNING: Once cleaning mode begins, the touchscreen and all functions will be unavailable for 30 seconds, including the
Emergency Buttons.
Installers Setup
To access the Z-Wave Settings menu via the
Installer Toolbox:
1. On the Home Screen, tap the Settings Menu
(
).
2. Enter the Installer Access Code to gain
access to the panel settings.
3. Scroll down then tap the Installer Toolbox
icon.