1.
2.
3.
4.
5.
RJ-45 LAN 10/100BaseT connector
12 V / 2 A DC supply terminal board (only if PoE is not used)
Restart/Factory reset button
Binary input/output terminal board (for application control)
micro SD card slot
Caution
Press the Restart button shortly to restart the device. The front panel
LED starts shining blue to signal the resetting process.
Press the Factory reset button for a rather long time (up to 10 s) to
factory reset the device. The front panel LED starts shining yellow to
signal the resetting process.
To Next Page
Loading...
