4.1.3.5 Settings
The Settings section helps you set the parameters. The following 2N Helios IP Mobile
®
options are available:
Device name – device name under which identifies itself to 2N Indoor Touch
®
other LAN devices via .2N Helios IP Mobile
®
Auto snapshot – Auto snapshot activation/deactivation.
Settings password – no user has access to the Settings and Add Devices
sections without knowing this password.
2N Helios IP Group Authentication
®
– authentication password for 2N Helios IP
®
. If the password is defined, the devices Devices / Add Devices / Local devices
scanner only searches the and devices with the 2N Helios IP 2N Indoor Touch
®
same password.
Volume level – speaker volume level.2N Indoor Touch
®
Mic sensitivity – microphone sensitivity.2N Indoor Touch
®
Caution
The and settings only adjust the active call Volume level Mic sensitivity
volume. The ringing volume is affected by the system launcher
configuration and cannot be controlled by the application. Set the
ringing volume here: .3.3 Launcher Configuration Audio
Ringing tone – select the ringing tone.2N Helios IP Mobile
®
SIP Proxy
SIP Proxy – SIP Proxy activation/deactivation
SIP Proxy settings – SIP Proxy setting menu
Video
Multicast/Unicast – video stream transmission type.2N Helios IP
Video deactivation – video stream display time for a device 2N Helios IP
selected from the Devices list.
Earlymedia – video stream transmission activation/deactivation during
incoming ringing from the SIP Proxy registered devices.
Recorder
To Next Page
Loading...
