1.
2.
3.
4.
5.
1.
2.
It is recommended that the power adapter be connected to the mains via a UPS
and reliable overvoltage protection.
Wall Mounting
2N Indoor Touch
®
is designed for wall mounting. Follow the steps below:
Unscrew the holder-fitting screws on the device sides.
Turn the metal holder slightly aside in the upper part of the device.
Move the holder downwards.
Fit the loose holder to the wall on the installation site.
Put the device on the holder and tighten the safety screws.
Follow the installation instructions printed on the device package.
Power Supply Connection
You can feed as follows:2N Indoor Touch
®
Use any 12 V / 2 A DC power adapter connected to the terminal board (see the
figure).
Use an Ethernet cable connected to a PoE supply or PoE supporting Ethernet
switch/router.
A successful operation is indicated by a status RGB LED or LCD display.
PoE Supply Connection
Use a standard straight RJ-45 terminated cable to connect to the 2N Indoor Touch
®
Ethernet. The device supports the 10BaseT and 100BaseT protocols. The Ethernet
connection state is indicated by the LEDs placed on the RJ-45 connector.
Refer to for the factory settings of the 3.3 Launcher Configuration 2N Indoor Touch
®
Ethernet interface.
Caution
Factory reset results in a change of the Ethernet interface configuration!
A defective Ethernet cable may lead to a high packet loss in the E
thernet and subsequent instability and poor video call quality!
To Next Page
Loading...
