Force sleep if device temperature is above – enable the stand-by mode
whenever the device temperature exceeds the defined internal temperature limit.
*
Reboot – restart the device.
Factory reset – reset the device factory values.
Enable service remote access - enables remote Telnet access. This function
should be always enabled and its intended for 2N service purposes only.
Caution
We do not recommend you to change the preset device temperature
limit to avoid device life impairment or system instability! In case the
device keeps exceeding the temperature limit, please check the
installation conditions!
Set Android launcher – delete the from 2N Indoor Touch launcher
®
2N Indoor
®
to use the Android 4.2.2 launcher. Set the Superuser rights for the Touch
selected applications in and then Software Setup ROOT access Set Android
.launcher
Caution
By enabling the function you delete the Set Android launcher 2N
®
. Press the Factory reset button on the device Indoor Touch launcher
backside (Subs. ) to reload the .2.1 2N Indoor Touch launcher
®
The Android launcher service depends on product licensing. You can
only install the applications that are equipped with an active APP licence
key. Refer to for the current licence state.System info/Licence/Keys
– display the standard Android settings. This section is Start Android setting
accessible with a developer's password only. Users do not have access to this
section.
– display the automatic restart settings. This restart will Setup automatic restart
be repeated at the given time every day.
To Next Page
Loading...
