Used input GPI 1/2 – set the input to control the door button. GPI 1 and GPI
2 are logical 1 by default. You can control only one of the digital inputs via
APK.
Minimum ringing time – set the lower ringing limit, i.e. make the application
ring for the time set in this parameter at least whenever the door button is
pressed.
Maximum ringing time – set the upper ringing limit, i.e. make the
application ring for the time set in this parameter at most whenever the
door button is pressed.
Bypass DND mode ON/OFF– set a DND bypass.
ON – the Door button service is active when DND is active.
OFF – the Door button service is inactive when DND is active.
External ringing notification
External ringing notification ON/OFF – activate/deactivate the External
notification service controlled via Relay 1/2. External notification is
activated by an incoming call or door button press if the Door button
service is inactive.
Inverted relay output ON/OFF – change the External notification behaviour
by setting Relay 1/2 to N/C or N/O.
ON – External notification is active when Relay 1/2 is N/O.
OFF – External notification is active when Relay 1/2 is N/C.
Used input Relay 1/2 – set Relay 1/2 for External notification control.
Always use just one relay.
Minimal ringing time – set the lower External notification limit, i.e. activate
External notification for the time set in this parameter at least.
Maximal ringing time – set the upper External notification limit, i.e. activate
External notification for the time set in this parameter at most.
Bypass DND mode ON/OFF– set a DND bypass.
ON – External ringing notification is active when DND is active.
OFF – External ringing notification is inactive when DND is active.
Configuration Import/Export
Import configuration – import the configuration from 2N Helios IP Mobile
®
a configuration file except for the devices added to Devices.
Export configuration – export the configuration into a 2N Helios IP Mobile
®
system configuration file or SD card.
To Next Page
Loading...
