12-3
z When a user profile is active, you cannot configure or remove the QoS policy applied to it.
z The QoS policies applied in user profile view support only the remark, car, and filter actions.
z Do not apply an empty QoS policy in user profile view, because even if you can do that, the user
profile cannot be activated.
Enabling a User Profile
A created user profile takes effect only after being enabled.
Follow these steps to enable a user profile:
To do… Use the command… Remarks
Enter system view system-view —
Enable a user profile
user-profile profile-name
enable
Required
A user profile is disabled by default.
z Only an enabled user profile can be used by a user. You cannot modify or remove the
configuration items in a user profile until the user profile is disabled.
z Disabling a user profile logs out the users using the user profile.
Displaying and Maintaining User Profile
To do… Use the command…
Display information about all the created user profiles display user-profile
12 Appendix
This chapter covers the following appendixes:
z Appendix A Acronym
z Appendix B Default Priority Mapping Tables
z Appendix C Introduction to Packet Precedences
To Next Page
Loading...
