3-17
Displaying and Maintaining RRPP
To do… Use the command… Remarks
Display brief RRPP information display rrpp brief
Display RRPP group
configuration information
display rrpp ring-group
[ ring-group-id ]
Display detailed RRPP
information
display rrpp verbose domain
domain-id [ ring ring-id ]
Display RRPP statistics
display rrpp statistics domain
domain-id [ ring ring-id ]
Available in any view
Clear RRPP statistics
reset rrpp statistics domain
domain-id [ ring ring-id ]
Available in user view
RRPP Configuration Examples
Single Ring Configuration Example
Networking requirements
z Device A, Device B, Device C, and Device D constitute RRPP domain 1, specify the primary
control VLAN of RRPP domain 1 as VLAN 4092, and RRPP domain 1 protects all VLANs;
z Device A, Device B, Device C and Device D constitute primary ring 1;
z Specify Device A as the master node of primary ring 1, GigabitEthernet 1/0/1 as the primary port
and GigabitEthernet 1/0/2 as the secondary port;
z Specify Device B, Device C and Device D as the transit nodes of primary ring 1, their
GigabitEthernet 1/0/1 as the primary port and GigabitEthernet 1/0/2 as the secondary port;
Figure 3-8 Network diagram for single ring configuration
Configuration procedure
1) Configuration on Device A
# Configure the suppression time of physical-link-state changes on GigabitEthernet 1/0/1 and
GigabitEthernet 1/0/2 as zero, disable STP, configure the two ports as trunk ports, and assign them to
all VLANs, and configure them to trust the 802.1p precedence of the received packets.
To Next Page
Loading...
