3Com 4210G Series - Ftp Test Configuration Example

23-25
[SwitchA-nqa-admin-test] type dhcp
[SwitchA-nqa-admin-test-dhcp] operation interface vlan-interface 2
[SwitchA-nqa-admin-test-dhcp] quit
# Enable DHCP test.
[SwitchA] nqa schedule admin test start-time now lifetime forever
# Disable DHCP test after the test begins for a period of time.
[SwitchA] undo nqa schedule admin test
# Display the result of the last DHCP test.
[SwitchA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 624/624/624
Square-Sum of round trip time: 389376
Last succeeded probe time: 2007-11-22 09:56:03.2
Extended results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of DHCP tests.
[SwitchA] display nqa history admin test
NQA entry(admin admin, tag test) history record(s):
Index Response Status Time
1 624 Succeeded 2007-11-22 09:56:03.2
FTP Test Configuration Example
Network requirements
Use the NQA FTP function to test the connection with a specified FTP server and the time necessary
for Device A to upload a file to the FTP server. The login username is admin, the login password is
systemtest, and the file to be transferred to the FTP server is config.txt.
Figure 24-5 Network diagram for FTP tests
Configuration procedure
# Create an FTP test group and configure related test parameters.
<DeviceA> system-view