3Com 4210G Series - Displaying and Maintaining Irf; Irf Configuration Examples; Irf Connection Configuration Example

26-18
Displaying and Maintaining IRF
To do… Use the command… Remarks
Display related information of the IRF display irf Available in any view
Display topology information of the IRF display irf topology Available in any view
Display the pre-configurations of all
members of the IRF (The
pre-configuration takes effect after the
reboot of the device.)
display irf configuration Available in any view
Display the master/slave switchover
states of IRF members
display switchover state
[ member-id ]
Available in any view
IRF Configuration Examples
IRF Connection Configuration Example
Network requirements
Three Switch 4210G series switches in an IRF form a bus connection. Their member IDs are 1, 2, and
3, as shown in
Figure 27-9.
Figure 27-9 Network diagram for IRF
1
Switch 1
Switch 2
2 43
Switch 3
1
3
2
4
3
1
2
4
Configuration procedure
1) The three devices are not connected. Power them on and configure them separately.
# Configure Switch 1.
<Switch1> system-view
[Switch1] irf member 1 renumber 1
Warning: Renumbering the switch number may result in configuration change or loss.
Continue?[Y/N]:y
[Switch1] irf member 1 irf-port 1 port 2
# Configure Switch 2.
<Switch2>system-view
[Switch2] irf member 1 renumber 2