23-6
If you execute the nqa entry command to enter the test group view with test type configured, you will
enter the test type view of the test group directly.
Configuring an NQA Test Group
Configuring an ICMP Echo Test
An ICMP echo test is used to test reachability of the destination host according to the ICMP echo reply
or timeout information. An ICMP echo test has the same function with the ping command but has more
abundant output information. You can use the ICMP echo test to locate connectivity problems in a
network.
Follow these steps to configure an ICMP echo test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as
ICMP echo and enter test type
view
type icmp-echo Required
Configure the destination
address for a test operation
destination ip
ip-address
Required
By default, no destination IP address
is configured for a test operation.
Configure the size of probe
packets sent
data-size size
Optional
100 bytes by default.
Configure the filler string of a
probe packet sent
data-fill string
Optional
By default, the filler string of a probe
packet is the hexadecimal number
00010203040506070809.
Specify the IP address of an
interface as the source IP
address of an ICMP echo
request
source interface
interface-type
interface-number
Optional
By default, no interface address is
specified as the source IP address of
ICMP probe requests.
If you use the source ip command to
configure the source IP address of
ICMP echo probe requests, the
source interface command is invalid.
The interface specified by this
command must be up. Otherwise, the
probe will fail.
To Next Page
Loading...
