3Com 4210G Series - Configuring the DNS Proxy; Displaying and Maintaining DNS; DNS Configuration Examples; Static Domain Name Resolution Configuration Example

10-5
Configuring the DNS Proxy
Follow these steps to configure the DNS proxy:
To do… Use the command… Remarks
Enter system view system-view —
Enable DNS proxy dns proxy enable
Required
Disabled by default.
Displaying and Maintaining DNS
To do… Use the command… Remarks
Display the static domain name
resolution table
display ip host
Display DNS server information display dns server [ dynamic ]
Available in
any view
Display domain name suffixes display dns domain [ dynamic ]
Display the information of the dynamic
domain name cache
display dns dynamic-host
Available in
any view
Clear the information of the dynamic
domain name cache
reset dns dynamic-host
Available in
user view
DNS Configuration Examples
Static Domain Name Resolution Configuration Example
Network requirements
Switch uses the static domain name resolution to access Host with IP address 10.1.1.2 through
domain name host.com.
Figure 10-3 Network diagram for static domain name resolution
Configuration procedure
# Configure a mapping between host name host.com and IP address 10.1.1.2.
<Sysname> system-view
[Sysname] ip host host.com 10.1.1.2
# Execute the ping host.com command to verify that the Switch can use the static domain name
resolution to get the IP address 10.1.1.2 corresponding to host.com.
[Sysname] ping host.com
PING host.com (10.1.1.2):