1-5
Configuring Protected VLANs for a Smart Link Group
Follow these steps to configure the protected VLANs for a smart link group:
To do… Use the command… Remarks
Enter system view
system-view —
Create a smart link group and enter
smart link group view
smart-link group group-id —
Configure protected VLANs for the
smart link group
protected-vlan reference-instance
instance-id-list
Required
By default, no
protected VLAN is
configured for a smart
link group.
The protected-vlan command configures protected VLANs for a smart link group by referencing
MSTIs. To view VLAN-to-MSTI mappings, use the display stp region-configuration command. For
VLAN-to-MSTI mapping configuration, refer to MSTP Configuration in the Access Volume.
Configuring Member Ports for a Smart Link Group
You can configure member ports for a smart link group either in smart link group view or in interface
view. The configurations made in these two views have the same effect.
In smart link group view
Follow these steps to configure member ports for a smart link group in smart link group view:
To do… Use the command… Remarks
Enter system view
system-view —
Create a smart link group and enter
smart link group view
smart-link group group-id —
Configure member ports for a smart
link group
port interface-type
interface-number { master |
slave }
Required
In interface view
Follow these steps to configure member ports for a smart link group in interface view:
To do… Use the command… Remarks
Enter system view
system-view —
Enter Ethernet interface view or layer 2
aggregate interface view
interface interface-type
interface-number
—
To Next Page
Loading...
