142 CHAPTER 3: DEVICE CONFIGURATION
To connect a computer to the hub or switch port on the telephone:
■ Use a Category 5 UTP cable with RJ-45 connectors.
■ Connect one end of the Category 5 cable to the computer’s Ethernet
network interface card (NIC).
■ Connect the other end of the cable to the Ethernet hub or switch port
on the underside of the telephone.
■ The telephone serves as an Ethernet hub (Model 1102) or switch
(Models 2102 and 2102-IR), connecting the computer to the LAN.
If you are using a 10 Mbps telephone (Model 1102), your transfer speed
is limited to 10 Mbps regardless of your LAN speed.
Attaching the Telephone Support Bracket
Slip the tabs on the telephone’s underside into the slots on the bracket,
and then snap the opposite mounting points into place. The telephone
support bracket can be attached in either of the positions in Figure 45
.
Figure 45 Attachment Positions for the Telephone Support Bracket
To Next Page
Loading...