206 CHAPTER 3: DEVICE CONFIGURATION
Changing Attendant
Console IP Settings
Although most configurations use IP On-the-Fly or DHCP to assign IP
addresses (and thus cannot manually change the addresses), if you use
Standard IP network protocol, you can manually change the IP address of
Attendant Consoles and other devices.
To set Attendant Console Feature IP settings:
1 Log on to the NBX NetSet utility using the administrator ID and password.
2 In the NBX NetSet - Main Menu window, click Device Configuration.
3 In the Device Configuration dialog box, click the Attendant Console tab.
4 In the list of Attendant Consoles, select the one that you want to update,
and then click IP Settings (Figure 69
).
Figure 69 Modify IP Settings Dialog Box
When you change IP Settings, all current calls through this device are
terminated.
To Next Page
Loading...