192 CHAPTER 3: DEVICE CONFIGURATION
Removing an
Attendant Console
To remove an NBX 1105 Attendant Console from the system:
1 In the NBX NetSet - Main Menu window, click Device Configuration. The
Device Configuration dialog box appears (Figure 49
).
2 Click the Attendant Console tab. The Attendant Console dialog box
appears (Figure 63).
3 Select the Attendant Console that you want to remove.
4 Click Remove. A dialog box prompts you to confirm the removal.
5 Click Yes. The system removes the Attendant Console.
Configuring
Attendant Console
Buttons
This section describes how to configure the buttons on the NBX 1105
Attendant Console. The Attendant Console buttons include:
■ 50 Access buttons. You can assign each button two settings.
■ A Shift button. This button switches between the two settings
allowed for each Access button.
■ Four Feature buttons, located below the Access buttons.
Configuring Feature Buttons
To map the Attendant Console Feature Buttons:
1 In the NBX NetSet - Main Menu window, click
Device Configuration. The
Device Configuration dialog box appears (Figure 49
).
2 Click the Attendant Console tab. The Attendant Console dialog box
appears (Figure 63).
3 Select the Attendant Console for which you want to map Feature
Buttons.
To Next Page
Loading...