Configuring the NBX 1105 Attendant Console 191
Name (Device Name) (Optional) A name that identifies this device when it
appears in lists in the NBX NetSet utility.
Extension (Associated
Telephone)
The telephone extension associated with this Attendant
Console.
Dialog Refresh How often to renew the information that appears on this
dialog box.
Choices: Manual; 5 10, 15, 30, or 60 seconds.
Device Refresh Forces the device to send a status message to the Call
Processor. (If you select this setting, you must click the
Apply button to make the change take effect.)
Reset Device Reboots the Attendant Console. Rebooting renews the
Console’s communications with the Call Processor and
causes the Attendant Console to receive a new
download of its operating software.
CAUTION: If the device has an active call, then Reset
Device disconnects the call.
Status The state of the device as of the last Dialog Refresh.
Online: The device was available.
Offline: The device was not available the last time that
the Call Processor tried to set up a call with this device.
Unknown: The device has not communicated with the
Call Processor during the previous 5 minutes.
Software Version The software version downloaded to the device.
Time Last Seen A timestamp identifying the last time the device
communicated with the Call Processor. During normal
operations, the Call Processor gathers status information
from each device every 30 seconds.
Error Count,
Error Code,
Performance Data,
Debug Data,
Actor Data
Advanced diagnostic data for use by technical support
personnel.
Table 29 Device Status Fields (continued)
Field Purpose
To Next Page
Loading...