282 CHAPTER 3: DEVICE CONFIGURATION
Removing an E1
Digital Line Card
You can remove a Digital Line Card at any time.
CAUTION: Removing a Digital Line Card may affect your Dial Plan.
To remove a Digital Line Card:
1 From the NBX NetSet - Main Menu window (Figure 97
), click Device
Configuration.
2 Click the Digital Line Cards tab (Figure 98).
3 From the Select Device Type pull-down list, select T1/ISDN Board List and
click Apply. A list of installed T1, ISDN PRI, and ISDN BRI boards appears in
the T1/ISDN Board List.
4 Select the board (Digital Line Card) you want to remove from the list.
5 Click Remove. A dialog box prompts you to confirm the removal.
6 Click Yes.
Configuring and
Managing T1
Digital Line Cards
These sections describe how to add and configure a T1 Digital Line Card
(
3C10116C) to connect to a T1 service provided by the local telephone
company:
■ Adding a T1 Digital Line Card
■ Configuring a T1 Digital Line Card for the DS1 Protocol
■ Configuring a T1 Digital Line Card for ISDN PRI Signaling
■ T1 Card Status Lights
■ Modifying a T1 Card
■ Modifying a T1 Group
■ Modifying T1 Card Channels
■ Modifying IP Settings for a T1 Card
■ Removing a T1 Digital Line Card
In the NBX NetSet utility, Digital Line Cards are referred to as cards or
boards.
Some people refer to a T1 Digital Line Card by using the category name
TEP (T1, E1, ISDN PRI).
To Next Page
Loading...