3Com SuperStack 3 NBX - Configuring and Managing BRI-ST Digital Line Cards

To Next Page

To Previous Page

Configuring and Managing BRI-ST Digital Line Cards 239

Configuring and

Managing BRI-ST

Digital Line Cards

These sections describe how to add and configure a BRI-ST Digital Line

Card to handle a BRI line with four BRI spans using the ST interface. In

this chapter, and in the NBX NetSet utility, Digital Line Cards are referred

to as cards and boards.

This section covers these topics:

■ Adding an ISDN BRI-ST Digital Line Card

■ Configuring the ISDN BRI-ST Digital Line Card

■ BRI-ST Card Status Lights

■ Modifying a BRI-ST Card

■ Adding or Modifying a BRI Group

■ Modifying BRI Card Channels

■ Modifying IP Settings for a BRI Card

■ Removing a BRI Digital Line Card

Each BRI-ST card (3C10164-S/T) supports the Basic Rate Interface protocol

(ST interface only).

Reset Click the Reset button to set all parameters to the

default values.

Table 41 Analog Terminal Adapter - Advanced Settings Parameters (continued)

Field Purpose