242 CHAPTER 3: DEVICE CONFIGURATION
5 To seat the BRI-ST card into the connectors, press the front of the card
firmly.
6 Tighten the left and right screws on the front of the BRI-ST card to secure
it to the chassis.
7 Wait 3 minutes.
CAUTION: When you insert the BRI-ST Digital Line Card, it begins an
initialization sequence. Also, because you enabled the Auto Discover
Digital Line Cards check box, the system recognizes the addition of the
BRI-ST card and begins to update its database. Allow 3 minutes for both
of these processes to be completed.
You are now ready to configure the ISDN BRI-ST Digital Line Card.
Configuring the ISDN
BRI-ST Digital Line
Card
These sections tell you how to use the NBX NetSet utility to set up your
BRI-ST Digital Line Card parameters:
■ Configuring for ISDN BRI Signaling
■ Configuring BRI Groups
■ Verifying BRI Group Membership
■ Completing the BRI-ST Configuration
Before you configure the BRI-ST card, you must configure the Dial Plan as
described in Chapter 2
.
Configuring for ISDN BRI Signaling
CAUTION: Before you begin to configure the BRI-ST card, be sure to wait
3 minutes after you insert the BRI-ST card into the chassis.
To configure for ISDN BRI signaling:
1 In the NBX NetSet - Main Menu window, click Device Configuration and
then select the Digital Line Cards tab.
2 In the T1/ISDN Board List, enter the MAC address of the BRI-ST board that
you recorded before you inserted the board into the chassis.
3 Select the BRI-ST board from the list and click Modify (Figure 81
).
To Next Page
Loading...