236 CHAPTER 3: DEVICE CONFIGURATION
Flash-hook Maximum
(msec)
Set this value to define the maximum time the hook
switch can be depressed for the NBX system to
recognize the event as a valid flash hook signal. If the
hook switched is depressed longer than this time, the
NBX system treats the event as if you had hung up the
telephone.
Default: Depends on the country in which the NBX
system is operating.
When you load a regional pack (Operations >
Regional Software) and select the tones and cadences
appropriate for your location (System Configuration >
System Settings > Regional Settings > Advanced), the
default value is set on your NBX system.
Minimum: 0 msec
Maximum: 2000 msec
Supervisory Disconnect
Pulse (msec)
Set this value to define the duration of the supervisory
disconnect pulse (battery denial) that disconnects the
current call.
Default: Depends on the country in which the NBX
system is operating.
When you load a regional pack (Operations >
Regional Software) and select the tones and cadences
appropriate for your location (System Configuration >
System Settings > Regional Settings > Advanced), the
default value is set on your NBX system.
Minimum: 0 (this setting disables the function)
Maximum: 2000 msec
Table 41 Analog Terminal Adapter - Advanced Settings Parameters (continued)
Field Purpose
To Next Page
Loading...