Configuring and Managing BRI-ST Digital Line Cards 247
Modifying a BRI Span
To modify a span:
1 On the Digital Line Cards tab, from the Select Device Type pull-down list,
select ISDN BRI Span List and then click Apply.
2 Select the span you want to modify from the Span List. Click Modify. The
Modify Span dialog box (Figure 84
) appears.
Figure 84 Modify Span Dialog Box — ISDN BRI
3 Make the changes that you want. Table 43 lists all span parameters. The
ISDN BRI-ST Digital Line Card supports two channels per span.
Table 43 Span Parameters
Parameter ISDN BRI Options
Span Name A name that helps you identify this span in span lists.
Interface Type N/A
CO Switch Protocol ETSI
Framing Type N/A
Line Code N/A
Line Length N/A
Timing Mode N/A
Terminal Endpoint Identifier (TEI) Enter the TEI number in the Manual TEI field or select the Assign
Automatic TEI check box. (When this value is changed, the card
reboots itself and all current calls on the card are lost.)
To Next Page
Loading...