318 CHAPTER 3: DEVICE CONFIGURATION
Figure 136 Channel Status Dialog Box — T1 ISDN PRI
6 View the status of the channel.
7 Refresh the Channel Status dialog box.
a From the Dialog Refresh pull-down list, select:
■ Manual — To manually refresh the Channel Status dialog box each
time you click the Apply button.
■ A time interval (5, 10, 15, 30, or 60 seconds) to automatically
refresh the Channel Status dialog box at the specified intervals.
b Enable the Device Refresh check box.
8 Click Apply, and then click OK.
Viewing DSP (Digital Signal Processor) Details
To view DSP (Digital Signal Processor) details:
1 Return to the Digital Line Cards tab.
2 From the Select Device Type list, select T1/ISDN Board List and click Apply.
3 Select the board you want and click Status.
4 In the Board Status dialog box, select a DSP from the DSP List and click
Details (Figure 91
).
To Next Page
Loading...