3D Systems Cube 2nd Generation User Manual

33
Set up a computer (WPS) network (cont’d)
5. Tap on “WI-FI SETUP”
Tap Here
6. Tap on “WPS” in the menu screen. The next screen will show your printer connecting to your computer and then if WPS
connection was successful. If connection was not successful, unplug the power to your Cube and then plug your Cube in;
Repeat the WPS WI-FI set up until you the touch screen reads “WPS Connection.”
Switching from ad-hoc to WPS connection or vice versa:
1. Close out Cubify Software.
2 Disconnect the Cube’s wireless connection through the “Internet Access” menu on your operating system.
3. Now follow steps for WPS / ad-hoc set up.
4. Re-open your software after your Cube successfully connects to WPS/ad-hoc.
Tap Here

3D Systems Cube 2nd Generation Specifications

General

Brand	3D Systems
Model	Cube 2nd Generation
Category	3D Printers
Language	English