3D Systems Cube 2nd Generation User Manual

46
2. Tap“Print”onthetouchscreenanduseleftorrightarrowsuntilyouseeyourCubeledisplayed.
4. The Cube will begin a ten minute heating process. During the heating process, the print tip and the print pad will reach
the temperatures that have been preset by the manufacturer. Once these temperatures are reached, your creation will
begintoprint.Oncethecreationisnishedprinting,yourtouchscreenwilldisplay“PrintFinished,”pressthecheckbox
toconrm.Waituntiltheprintpadiscompletelycoolbeforeremovingyourprint.
3. Taponyour.Cubele;theprinttouchscreenwillappearshowingthetotaltimeitwilltaketoprintyourcreationandthe
time left to complete it during printing. It also shows the maximum height of your creation and the current height while
printing.
Tap
Here
Aborting Your Print
Toabortyourcreationduringwarmuporprinting,ngertaptheSTOPbuttonontouchscreen.Thenextscreenwillread
“Are you sure you want to abort the print?” Finger tap the check box to abort or tap the X box to cancel. Wait until the print
tip and the print pad completely cools before touching.
WARNING – PRINTJET NOZZLE TIP BE-
COMES EXTREMELY HOT DURING SET-
UP AND OPERATION. DO NOT TOUCH
NOZZLE.
WARNING – PRINTJET NOZZLE TIP
BECOMES EXTREMELY HOT DUR-
ING SET-UP AND OPERATION. DO
NOT TOUCH NOZZLE.
Tap
Here

3D Systems Cube 2nd Generation Specifications

General

Brand	3D Systems
Model	Cube 2nd Generation
Category	3D Printers
Language	English