3D Systems Cube 2nd Generation - Printing from the USB Memory Stick

45
2. OntheCubetouchscreen,ngertapcheckboxtostartthebuildleortaptheX box to cancel.
3. The Cube will begin a ten minute heating process. During the heating process, the print tip and the print pad will reach the
temperatures that have been preset by the manufacturer. Once these temperatures are reached, your creation will begin to
print.
Tap here
WARNING – PRINTJET NOZZLE TIP BECOMES EXTREMELY HOT DURING SET-UP AND OPERATION. DO
NOT TOUCH NOZZLE.
Do not change cartridge material during printing; doing so may damage the Cube.
NOTE: During printing operation, please do not place a cover over your Cube. The Cube generates heat during
printing and if covered, it can cause damage to the Cube.
Printing From the USB Memory Stick
1. IfyouareusingyourUSBmemorysticktodownloadyourCubele,pleaseinstalltheUSBmemorystickintotheUSBporton
yourcomputer.OpenthelefolderwhereyourCubeleislocatedandsaveitontheUSBmemorystick.Removememory
stick and install it into the Cube’s USB port.