3D Systems Cube 2nd Generation - Maintaining Your Cube; Cleaning the Exterior; Cleaning the Print Pad; Cleaning the Print Tip

53
MAINTAINING YOUR Cube
26
Cleaning the Exterior
• Clean the Cube’s exterior with a lint free cloth and water.
Dampen the cloth with water and wipe the outer surfaces of
any debris that is visible.
Cleaning the Print Pad
• Submergeprintpadinacontainerlledwithwarmcity(tap)
water. Please do not use well water; it contains certain min-
eralsthatmaymakeyourcreationdifculttoremovefrom
the print pad.
• Rinse pad under tap water and dry using a lint free wipe.
Cleaning the Print Tip
WARNING – PRINTJET NOZZLE TIP
BECOMES EXTREMELY HOT DUR-
ING SET-UP AND OPERATION. DO
NOT TOUCH NOZZLE.
• Using the small pliers, pull away any plastic debris away from the nozzle tip.
• If the debris is stubborn, the nozzle may need to be heated to make the debris soft
enough to remove.