3M GMI PS200 Series - Key Monitor Features; Datalogging Capabilities; Monitor Filters

64171, Rev. 10/May 2019
3M™ GMI™ PS200 PORTABLE GAS MONITOR
INTRODUCTION
2-3
2.2. Features
• Compact, lightweight and robust.
• Measurement and display of up to 4 gases.
• Simple 2 button operation.
• Audible, visual (hi-viz) flashing LED’s and vibrating alarms.
• Audible and visual confidence signal (configurable), confirming monitor operation to the user.
• Green display during normal operation and red during alarm condition.
• Internal pump (optional).
• Manual and automatic data logging.
• Internal Li-Ion (Lithium Ion) rechargeable battery.
• Maximum recharge time of 4 hours.
• Robust clip to allow fitting to belt, pocket, etc.
• Communications interface to allow downloading of stored data.
• Fully certified to international standards.
• Comprehensive range of accessories .
• Quick Configuration Display allows the configuration to be viewed without fully switching the
monitor ON.
Typical operating parameters are detailed in
Section APPENDIX A. OPERATING PARAMETERS & SEN-
SOR TYPES
of this manual.
2.3. Datalogging
Datalogging allows gas measurements, event logs, bump tests, and calibration details to be stored
for downloading to a PC/Laptop via a USB connection. Typically, the monitor can store up to 6
months of data (refer to
Section APPENDIX A. OPERATING PARAMETERS & SENSOR TYPES).
2.3.1. Accessing Logged Data
Download data from the monitor to a PC/Laptop using the standard charging/comms cable and
additional software. Contact the 3M GMI Sales Department for further details.
2.4. Filters
Filters protect the monitor from water and dust ingress. Check filters regularly and replace as neces-
sary (refer to
Section 8.2. Replace Filters).