64171, Rev. 10/May 2019
3M™ GMI™ PS200 PORTABLE GAS MONITOR
RECHARGING THE BATTERIES
7-1
7. RECHARGING THE BATTERIES
7.1. General
Use only 3M GMI chargers to recharge monitor.
The battery should be recharged when:
• ‘LOW BATTERY’ or ‘BAT FAULT’ appears on the display.
• The monitor will not switch on.
7.2. Recharge Monitor Using the Charging/Comms Clip
1. Connect the supplied Charging/Comms Clip to the monitor. Ensure the locating tongue on the
clip engages with the monitor locating slot and is firmly seated (refer to
Figure 7-1:
Charging/Comms Clip Connection).
Figure 7-1: Charging/Comms Clip Connection
2. Connect the supplied MINI-USB to USB Cable to the Charging/Comms Clip.
WARNING: CHARGING IS ONLY PERMITTED IN A NON-HAZARDOUS AREA.
CAUTION: Switch the monitor off when charging.
Contact
Pads (4)
Charging/Comms Clip
(P/N 64260)
Locating Slot
Locating Tongue
To Next Page
Loading...
