page 13 | Document No.: TH-930-001 - 1/26/2015
A10 Thunder Series 930 Installation Guide
Power-On
Rack-mount installation instructions are available in “Rack Mount Kit Installation” on page 27.
Sliding rail installation instructions are available in “
Sliding Rail Kit Installation” on page 31.
Power-On
The device automatically boots when the power plug is connected to an electrical outlet. If the unit does not boot automat-
ically, it can be manually booted by quickly flipping the power switch.
NOTE: Power OFF – To perform a graceful shutdown, use the shutdown command in the CLI. If
you made any changes to the device configuration, you will be prompted to save your
configuration information before the device powers down.
Force Power OFF – If the system stops working and requires a forced shutdown, press
and hold the power switch four seconds. Keep in mind that this forced shutdown will
cause a loss of configuration information that has not be manually saved.
Supported Models AX1030, AX3030, AX930
TH1030S, TH3030S, TH930
AX1030, AX3030, AX930
TH1030S, TH3030S, TH930
2-Post Installation? Yes No
4-Post Installation? Yes Yes
4-Post Depth 31 inches 36 inches
Mounting Thread No No
Double 4-Post Yes Yes
Default Bundle Yes No
Item Rack Mount Kit Sliding Rail Kit