EasyManuals Logo

A10 Thunder series 930 User Manual

A10 Thunder series 930
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
A10 Thunder Series 930 Installation Guide
Configuring a New ACOS Device Using an Existing Configuration
Document No.: TH-930-001 - 1/26/2015 | page 24
Save the Configuration Changes
Configuration changes made so far must be saved to the system memory to take effect when the system reboots. Otherwise,
a power interruption (for example) could cause the system to be unavailable from the Web interface, in which case the con-
sole configuration would need to be repeated. Saving the configuration changes prevents this inconvenience. To write the
current configuration to system memory:
ACOS(config)#write mem
Building configuration...
[OK]
Configuring a New ACOS Device Using an Existing
Configuration
If you are planning to configure the new ACOS device by loading the configuration from another ACOS device:
1. On the configured ACOS device, use the copy CLI command to save the startup-config to a remote server.
2. On the new ACOS device, copy the configured ACOS device’s startup-config from the remote server onto the new
ACOS device.
3. Reboot the new ACOS device.
4. Modify parameters as needed (such as IP addresses).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the A10 Thunder series 930 and is the answer not in the manual?

A10 Thunder series 930 Specifications

General IconGeneral
BrandA10
ModelThunder series 930
CategorySwitch
LanguageEnglish

Related product manuals