page 9 | Document No.: TH-930-001 - 1/26/2015
Getting Started
This guide describes how to physically install the A10 Thunder Series 930 ADC model, and how to configure the MGMT
(management) interface for network access to the Command-Line Interface (CLI).
FIGURE 1 Thunder 930 (Front Panel View)
Inspection
Inspect the box carefully before opening it. If the box is damaged, contact the shipper for instructions on filing a claim.
Opening a damaged box before inspection by the shipper will void any potential shipping claims.
CAUTION: Do not attempt to install or operate damaged equipment. As with any electrical equip-
ment, personal injury or damage to other equipment can result from commissioning
damaged electrical equipment.
Regulations
Follow all applicable regulations for installation of electrical equipment.
Unpacking
Carefully unpack your ACOS device and included items from the box.
Check the Contents
Confirm that the following items are included with the ACOS device:
• Cables: one AC power, two Cat-5E Ethernet, one Serial to RJ-45 console
• Hardware: rack-mount kit and sliding-rail kit
To Next Page
Loading...
Need help?
General
