Need help?Do you have a question about the A10 Thunder series 930 and is the answer not in the manual?
Guidance on lifting and placing the chassis safely, recommending a two-person job or lifting device.
Specifies that installation should only be done by a trained electrician or qualified personnel.
Warns about device sensitivity to ESD and the requirement for an ESD wrist strap.
Provides instructions and figures for installing the DC power supply, including wiring details.
Details the procedure for removing and inserting power supply units without powering down the device.
Steps for performing initial configuration via CLI, including console connection and IP setup.
Recommendation and procedure for changing the default admin password for enhanced security.
Guidance on lifting and sliding the chassis onto the installed rails in the rack.
To Next Page
General