5 Confirm that there is nothing on the pan and press the
PRINT key. The balance measures the zero point and
displays the measured value. Do not allow vibration or
drafts to affect the balance.
The balance displays the target weight value.
6 Place the displayed target weight on the pan and press the
PRINT key. The balance measures the target weight and
displays the measured value. Do not allow vibration or
drafts to affect the balance.
7 The balance displays end . Remove the weight from the
pan.
8 When the GLP output is set, the balance displays glp1 and
outputs āCalibration Test Reportā.
9 The balance will automatically return to the weighing
mode.
To Next Page
Loading...
