A&D FX-2000i - Clock and Calendar Function

52
10.9. Clock and Calendar Function (Only for FZ- i / FZ- i WP / FZ-GD series)
The FZ-i / FZ-i WP / FZ-GD series balance is equipped with a clock and calendar function. When the “GLP
output (info)” parameter is set to “1” or “2” and the “Time/Date output (5-td)” parameter is set to “1”, “2” or “3”,
the time and date are added to the output data. Set or confirm the time and date as follows:
Note
Time and date cannot be confirmed and set with the FX-i
/
FX-iWP
/
FX-GD series.
Operation
1 Press and hold the SAMPLE key until ba5fnc of the
function table is displayed.
2 Press the SAMPLE key several times to display
Cl adj .
3 Press the PRINT key. The balance enters the mode to
confirm or set the time and date.
Confirming the date
4 The current date is displayed with all the digits blinking.
 When the date is correct and the operation is to be
finished, press the CAL key and go to step 8.
 When the date is correct and the time is to be
confirmed, press the SAMPLE key and go to step 6.
 When the date is not correct and is to be changed,
press the RE-ZERO key and go to step 5.
Note
The year is expressed using a two-digit format. For
example, the year 2010 is expressed as “10”.
Setting the date (with part of the digits blinking)
Before setting the date, set the order in which to display year,
month and date.
RE-ZERO key To select “YMD”, ”MDY” or “DMY”
SAMPLE key To make the date and time blink and
enable it to be changed.
5 Set the date using the following keys.
SAMPLE key To select the digits to change the
value. The selected digits blink.
RE-ZERO key To increase the value by one.
MODE key To decrease the value by one.
PRINT key To store the new setting, display
end and go to step 6.
CAL key To cancel the new setting and
go to step 6.
Confirm
To the time
setting mode
To the time
setting mode