A&D GF-30K - 5 Weighing Units; Units

12
5. Weighing Units
5-1. Units
With the balance, the following weighing units and weighing modes are available :
A unit or mode can be selected and stored in the function table as described in "5-2.Changing
the Units".
If a weighing mode (or unit of weight) has been turned off, that mode or unit will be missing in
the sequence. Tael has four varieties, one of which can be selected and installed at the factory.
To select a unit or mode for weighing, press the MODE key.
For details about the units and modes, see the table below:
Name (unit, mode)
Abbre-
viation
Display
Function table
(Storing mode)
Conversion factor
1 g =
Gram g 1 g
Kilogram kg 1000 g
Counting mode pcs pcs -
Percent mode % -
Ounce (Avoir) OZ 28.349523125 g
Pound Lb 453.59237 g
Pound/Ounce L OZ l0
1 Lb = 16 oz,
1 oz = 28.349523125 g
Troy Ounce OZt 31.1034768 g
Metric Carat ct 0.2 g
Momme mom 3.75 g
Pennyweight dwt 1.55517384 g
Grain (UK) GN 0.06479891 g
Tael (HK general, Singapore) 37.7994 g
Tael (HK jewelry) 37.429 g
Tael (Taiwan) 37.5 g
Tael (China)
TL
31.25 g
Tola (India) t 11.6638038 g
Messghal MS 4.6875 g
Density mode
DS
is used to
show the density
-
Programmable-unit (Multi-unit) Mlt - -
Note The unit Grain is not available for the GX-32K and GF-32K.
g kg pcs % OZ Lb L OZ OZt
DS MS t TL GN dwt mom ct
Counting mode
Percent mode
Density mode ( To use this mode, it must be stored in the function table as described on the nex
t
page. For details about this mode, refer to "15. Density Measurement".
To select this mode, press the MODE key until the processing indictor blinks with
the unit "g" displayed. " " appears only when the density value is displayed. )
Programmable-unit. No unit displayed. Refer to "13. Programmable Units" for details.